HD6433636SW datasheet(203/418 Pages) RENESAS

203 / 418 page

189

9.4.3

Noise Canceller Circuit

The noise canceller circuit built into the H8/3637S Series is a digital low-pass filter that rejects

high-frequency pulse noise in the input at the input capture pin. The noise canceller circuit is

enabled by the noise canceller select (NCS)* bit in port mode register 2 (PMR2).

Figure 9.7 shows a block diagram of the noise canceller circuit.

Input capture

signal

Sampling clock

Match

detection

circuit

Noise

canceller

output

t: Selected by bits CKS1, CKS0.

Sampling clock

latch

∆ t

∆

Figure 9.7 Block Diagram of Noise Canceller Circuit

The noise canceller consists of five latch circuits connected in series, and a match detection

circuit. When the noise canceller function is disabled (NCS = 0), the system clock is selected as

the sampling clock. When the noise canceller is enabled (NCS = 1), the internal clock selected by

bits CKS1 and CKS0 in TMG becomes the sampling clock. The input signal is sampled at the

rising edge of this clock pulse. Data is considered correct when the outputs of all five latch circuits

match. If they do not match, the previous value is retained. Upon reset, the noise canceller output

is initialized after the falling edge of the input capture signal has been sampled five times.

Accordingly, after the noise canceller function is enabled, pulses that have a pulse width five times

greater than the sampling clock will be recognized as input capture signals.

If the noise canceller circuit is not used, the input capture signal pulse width must be at least 2ø or

2ø

SUB in order to ensure proper input capture operation.

Note:

Rewriting the NCS bit may cause an internal input capture signal to be generated.

HD6433636SW Folha de dados(PDF) 203 Page - Renesas Technology Corp