UCD3138064ARGCR.A datasheet(34/84 Pages) TI2

34 / 84 page

Filter Duty

Low – Lower Threshold

High – Lower Threshold

Control

Auto Config High

Auto Config Mid

High – Upper Threshold

Low – Upper Threshold

Full Range

Automatic Mode Switching

With Hysteresis

UCD3138064A

SLUSCA5B – DECEMBER 2015 – REVISED JANUARY 2017

www.ti.com

Submit Documentation Feedback

Product Folder Links: UCD3138064A

Detailed Description

6.4.4.3

Mechanism For Automatic Mode Switching

The UCD3138064A allows the customer to enable up to two distinct levels of automatic mode switching.

These different modes are used to enhance light load operation, short circuit operation and soft start.

Many of the configuration parameters for the DPWM are in DPWM Control Register 1. For automatic

mode switching, some of these parameters are duplicated in the Auto Config Mid and Auto Config High

registers.

If automatic mode switching is enabled, the filter duty signal is used to select which of these three

registers is used. There are 4 registers which are used to select the points at which the mode switching

takes place. They are used as shown in Figure 6-12 below.

Figure 6-12. Automatic Mode Switching

As shown, the registers are used in pairs for hysteresis. The transition from Control Register 1 to Auto

Config Mid only takes place when the Filter Duty goes above the Low Upper threshold. It does not go

back to Auto Config Mid until the Low Lower Threshold is passed. This prevents oscillation between

modes if the filter duty is close to a mode switching point.

6.4.5

DPWMC, Edge Generation, IntraMux

The UCD3138064A has hardware for generating complex waveforms beyond the simple DPWMA and

DPWMB waveforms already discussed – DPWMC, the Edge Generation Module, and the IntraMux.

DPWMC is a signal inside the DPWM logic. It goes high at the Blanking A begin time, and low at the

Blanking A end time.

The Edge Gen module takes DPWMA and DPWMB from its own DPWM module, and the next one, and

uses them to generate edges for two outputs. For DPWM3, the DPWM0 is considered to be the next

DPWM. Each edge (rising and falling for DPWMA and DPWMB) has 8 options which can cause it.

UCD3138064ARGCR.A Folha de dados(PDF) 34 Page - Texas Instruments