UCD3138064ARGCR datasheet(40/83 Pages) TI1

40 / 83 page

CYCLE BY CYCLE

CLIM

FAULT - CBC

FAULT MODULE

FAULT IN

FAULT FLAG

UCD3138064A

SLUSCA5A – DECEMBER 2015 – REVISED AUGUST 2016

www.ti.com

Submit Documentation Feedback

Product Folder Links: UCD3138064A

Detailed Description

Figure 6-18. Fault Module

All fault modules provide immediate fault detection but only once per DPWM switching cycle. Each one of

the fault modules own a separate max_count and the fault flag will be set only if sequential cycle-by-cycle

fault count exceeds max_count.

Once the fault flag is set, DPWMs need to be disabled by DPWM_EN going low in order to clear the fault

flags. Please note, all four Fault Modules share the same DPWM_EN control, all fault flags (output of Fault

Modules) will be cleared simultaneously.

All four Fault Modules share the same global FAULT_EN as well. Therefore a specific Fault Module

cannot be enabled/ disabled separately.

Figure 6-19. Cycle-By-Cycle Block

Unlike Fault Modules, only one Cycle by Cycle block is available in each DPWM module.

The Cycle by Cycle block works in conjunction with CBC Fault Module and enables DPWM reaction to

signals arriving from the Analog Peak current mode (PCM) module.

The Fault Mux Module supports the following basic functions:

•

4 digital comparators with programmable thresholds and fault generation

•

Configuration for 7 high speed analog comparators with programmable thresholds and fault generation

•

External GPIO detection control with programmable fault generation

•

Configurable DPWM fault generation for DPWM Current Limit Fault, DPWM Over-Voltage Detection

Fault, DPWM A External Fault, DPWM B External Fault and DPWM IDE Flag

•

Clock Failure Detection for High and Low Frequency Oscillator blocks

•

Discontinuous Conduction Mode Detection

UCD3138064ARGCR Folha de dados(PDF) 40 Page - Texas Instruments