TUSB8042AI datasheet(38/64 Pages) TI2

38 / 64 page

8.24 Additional Feature Configuration Register

Figure 8-23. Register Offset F0h

Bit No.

Reset State

Table 8-24. Bit Descriptions – Additional Feature Configuration Register

Bit

Field

Type

Description

7:5

Reserved

Reserved. This field defaults to 3'b000 and must not be changed.

stsOutputEn

Status output enable. This field when set enables of the Status output

signals, HS_UP, HS_SUSPEND, SS_UP, SS_SUSPEND.

0 = STS outputs are disabled.

1 = STS outputs are enabled.

This bit can be loaded by EEPROM or overwritten by a SMBUS host.

3:1

pwronTime

Power On Delay Time. When the efuse_pwronTime field is all 0s, this

field sets the delay time from the removal disable of PWRCTL to the

enable of PWRCTL when transitioning battery charging modes. For

example, when disabling the power on a transition from ACP to DCP

Mode. The nominal timing is defined as follows:

TPWRON_EN = (pwronTime x 1) x 200ms

(1)

This field can be overwritten by EEPROM contents or by an SMBus

host.

usb3spreadDis

USB3 Spread Spectrum Disable. This bit allows firmware to disable the

spread spectrum function of the USB3 phy PLL.

0 = Spread spectrum function is enabled

1= Spread spectrum function is disabled

This bit can be loaded by EEPROM or overwritten by a SMBUS host.

TUSB8042A

SLLSF93A – JUNE 2019 – REVISED JANUARY 2025

www.ti.com

Submit Document Feedback

Product Folder Links: TUSB8042A

TUSB8042AI Folha de dados(PDF) 38 Page - Texas Instruments