TMS320DM647 datasheet(96/166 Pages) TI

96 / 166 page

www.ti.com

6.10 External Memory Interface A (EMIFA)

6.10.1 EMIFA Device-Specific Information

TMS320DM647/TMS320DM648

Digital Media Processor

SPRS372 – MAY 2007

The EMIFA can interface to a variety of external devices or ASICs, including:

• Pipelined and flow-through synchronous-burst SRAM (SBSRAM)

• ZBT (zero bus turnaround) SRAM and late write SRAM

• Synchronous FIFOs

• Asynchronous memory, including SRAM, ROM, and Flash

Timing analysis must be done to verify all ac timing requirements are met. TI recommends utilizing I/O

buffer information specification (IBIS) to analyze all ac timing.

To properly use IBIS models to attain accurate timing analysis for a given system, see the Using IBIS

Models for Timing Analysis Application Report (literature number SPRA839).

To maintain signal integrity, serial termination resistors should be inserted into all EMIFA output signal

lines.

A race condition may exist when certain masters write data to the EMIFA. For example, if master A

passes a software message via a buffer in external memory and does not wait for indication that the write

completes, when master B attempts to read the software message, then the master B read may bypass

the master A write and, thus, master B may read stale data and, therefore, receive an incorrect message.

Some master peripherals (e.g., EDMA3 transfer controllers) will always wait for the write to complete

before signaling an interrupt to the system, thus avoiding this race condition. For masters that do not have

hardware specification of write-read ordering, it may be necessary to specify data ordering via software.

If master A does not wait for indication that a write is complete, it must perform the following workaround:

1. Perform the required write.

2. Perform a dummy write to the EMIFA module ID and revision register.

3. Perform a dummy read to the EMIFA module ID and revision register.

4. Indicate to master B that the data is ready to be read after completion of the read in step 3. The

completion of the read in step 3 ensures that the previous write was done.

Peripheral Information and Electrical Specifications

Submit Documentation Feedback

TMS320DM647 Folha de dados(PDF) 96 Page - Texas Instruments