HD64F2149YV datasheet(700/1075 Pages) RENESAS

700 / 1075 page

Section 20 A/D Converter

Rev. 3.00 Jan 18, 2006 page 672 of 1044

REJ09B0280-0300

20.4

Operation

The A/D converter operates by successive approximations with 10-bit resolution. It has two

operating modes: single mode and scan mode.

20.4.1

Single Mode (SCAN = 0)

Single mode is selected when A/D conversion is to be performed on a single channel only. A/D

conversion is started when the ADST bit is set to 1 by software, or by external trigger input. The

ADST bit remains set to 1 during A/D conversion, and is automatically cleared to 0 when

conversion ends.

On completion of conversion, the ADF flag is set to 1. If the ADIE bit is set to 1 at this time, an

ADI interrupt request is generated. The ADF flag is cleared by writing 0 after reading ADCSR.

When the operating mode or analog input channel must be changed during analog conversion, to

prevent incorrect operation, first clear the ADST bit to 0 in ADCSR to halt A/D conversion. After

making the necessary changes, set the ADST bit to 1 to start A/D conversion again. The ADST bit

can be set at the same time as the operating mode or input channel is changed.

Typical operations when channel 1 (AN1) is selected in single mode are described next. Figure

20.3 shows a timing diagram for this example.

1. Single mode is selected (SCAN = 0), input channel AN1 is selected (CH1 = 0, CH0 = 1), the

A/D interrupt is enabled (ADIE = 1), and A/D conversion is started (ADST = 1).

2. When A/D conversion is completed, the result is transferred to ADDRB. At the same time the

ADF flag is set to 1, the ADST bit is cleared to 0, and the A/D converter becomes idle.

3. Since ADF = 1 and ADIE = 1, an ADI interrupt is requested.

4. The A/D interrupt handling routine starts.

5. The routine reads ADCSR, then writes 0 to the ADF flag.

6. The routine reads and processes the conversion result (ADDRB).

7. Execution of the A/D interrupt handling routine ends. After that, if the ADST bit is set to 1,

A/D conversion starts again and steps 2 to 7 are repeated.

HD64F2149YV Folha de dados(PDF) 700 Page - Renesas Technology Corp