HD64F2149YV datasheet(544/1075 Pages) RENESAS

544 / 1075 page

Section 16 I

2C Bus Interface

Rev. 3.00 Jan 18, 2006 page 516 of 1044

REJ09B0280-0300

Bit 3—Arbitration Lost (AL): This flag indicates that arbitration was lost in master mode. The

2C bus interface monitors the bus. When two or more master devices attempt to seize the bus at

nearly the same time, if the I

2C bus interface detects data differing from the data it sent, it sets AL

to 1 to indicate that the bus has been taken by another master.

AL is cleared by reading AL after it has been set to 1, then writing 0 in AL. In addition, AL is

reset automatically by write access to ICDR in transmit mode, or read access to ICDR in receive

mode.

Bit 3

Description

Bus arbitration won

(Initial value)

[Clearing conditions]

1. When ICDR data is written (transmit mode) or read (receive mode)

2. When 0 is written in AL after reading AL = 1

Arbitration lost

[Setting conditions]

1. If the internal SDA and SDA pin disagree at the rise of SCL in master transmit

mode

2. If the internal SCL line is high at the fall of SCL in master transmit mode

Bit 2—Slave Address Recognition Flag (AAS): In I

2C bus format slave receive mode, this flag is

set to 1 if the first frame following a start condition matches bits SVA6 to SVA0 in SAR, or if the

general call address (H'00) is detected.

AAS is cleared by reading AAS after it has been set to 1, then writing 0 in AAS. In addition, AAS

is reset automatically by write access to ICDR in transmit mode, or read access to ICDR in receive

mode.

HD64F2149YV Folha de dados(PDF) 544 Page - Renesas Technology Corp