AD7993 datasheet(23/27 Pages) AD

23 / 27 page

AD7994/AD7993

–23–

REV. PrF

PRELIMINARYTECHNICAL DATA

Figure 14. Reading two bytes of data from the Conversion

Result Register

Figure 13. Reading a single byte of data from a selected

device will win communication rights via standard I

arbitration during the slave address transfer.

The ALERT output becomes active when the value in the

Conversion Result Register exceeds the value in the

DATAHIGH Register or falls below the value in the

DATALOW Register . It is reset when a write operation to

the Configuration register sets D1 to a 1, or when the

conversion result returns N LSBs below or above the value

stored in the DATAHIGH Register or DATALOW Register

respectively. N is the value in the Hysteresis register. (See

Limit Registers section)

The ALERT output requires an external pull-up resistor.

This can be connected to a voltage different from VDD

provided the maximum voltage rating of the ALERT out-

put pin is not exceeded. The value of the pull-up resistor

depends on the application, but should be as large as pos-

sible to avoid excessive sink currents at the ALERT out-

put.

ALERT/BUSY PIN

The ALERT/BUSY may be configured as an Alert or

Busy ouput as shown in Table VI.

SMBus ALERT

The AD7994/AD7993 ALERT output is an SMBus inter-

rupt line for devices that want to trade their ability to

master for an extra pin. The AD7994/AD7993 is a slave

only device and uses the SMBus ALERT to signal the

host device that it wants to talk. The SMBus ALERT on

the AD7994/AD7993 is used as an out of conversion

range indicator (a limit violation indicator).

The ALERT pin has an open-drain configuration which

allows the ALERT outputs of several AD7994/AD7993

devices to be wired-AND together when the ALERT pin

is active low. D0 of the Configuration Register is used to

set the active polarity of the ALERT output. The power-

up default is active low. The ALERT function can be

disabled or enabled by setting D2 of the Configuration

The host device can process the ALERT interrupt and

simultaneously access all SMBus ALERT devices through

the alert response address. Only the device which pulled

the ALERT low will acknowledge the ARA (Alert Re-

sponse Address). If more than one device pulls the

ALERT pin low, the highest priority (lowest address)

SDA

NO ACK. BY

MASTER

START BY

MASTER

FRAME 1

SERIAL BUS ADDRESS BYTE

FRAME 2

SINGLE DATA BYTE FROM AD7994/3

ACK. BY

AD7994/3

SCL

STOP BY

MASTER

SDA

ACK. BY

MASTER

START BY

MASTER

FRAME 1

SERIAL BUS ADDRESS BYTE

FRAME 2

MOST SIGNIFICANT DATA BYTE FROM

AD7994/3

ACK. BY

AD7994/3

Alert_

Flag

D10

SCL

D11

NO ACK. BY

MASTER

FRAME 3

LEAST SIGNIFICANT DATA BYTE FROM

AD7994/3

D1/0

D0/0

STOP BY

MASTER

SCL (CONTINUED)

SDA (CONTINUED)

CH ID1 CH ID0

AD7993 Folha de dados(PDF) 23 Page - Analog Devices

AD7993 Folha de dados(HTML) 23 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Folha de dados Download

Ligação URL