A6985F datasheet(26/77 Pages) STMICROELECTRONICS

26 / 77 page

Functional description

A6985F

26/77

DocID027738 Rev 2

5.5.2

Low consumption mode (LCM)

The low consumption mode maximizes the efficiency at light-load. The regulator prevents

the switching activity whenever the switch peak current request is lower than the ISKIP

threshold (350 mA typical). As a consequence the A6985F device works in bursts and it

minimizes the quiescent current request in the meantime between the switching operation.

In LCM operation, the pin SYNCH/ISKIP level dynamically defines the ISKIP current

threshold (see Table 11).

The ISKIP programmability helps to optimize the performance in terms of the output voltage

ripple or efficiency at the light-load, that are parameters which disagree each other by

definition.

A lower skip current level minimizes the voltage ripple but increases the switching activity

(time between bursts gets closer) since less energy per burst is transfered to the output

voltage at the given load. On the other side, a higher skip level reduces the switching activity

and improves the efficiency at the light-load but worsen the voltage ripple.

No difference in terms of the voltage ripple and conversion efficiency for the medium and

high load current level, that is when the device operates in the discontinuous or continuous

mode (DCM vs. CCM).

Figure 14 and Figure 15 report the efficiency measurements to highlight the ISKIPH and

ISKIPL efficiency gap at the light-load also in comparison with the LNM operation. The same

efficiency at the medium / high load is confirmed at different ISKIP levels.

Figure 14. Light-load efficiency comparison at different ISKIP - linear scale

Table 11. ISKIP current level

SYNCH / ISKIP (pin 4)

ISKIP current threshold

LOW

ISKIPH = 0.35 A typical

HIGH

ISKIPL = 0.1 A typical

A6985F Folha de dados(PDF) 26 Page - STMicroelectronics