SLA24C01-SSLASHP datasheet(8/27 Pages) SIEMENS

8 / 27 page

SLx 24C01/02/P

Semiconductor Group

1998-07-27

The conventions for the serial clock line and the bidirectional data line are shown in

figure 4.

Figure 4

2C-Bus Timing Conventions for START Condition, STOP Condition, Data Valida-

tion and Transfer of Acknowledge ACK

Standby

Mode in which the bus is not busy (no serial transmission, no

programming): both clock (SCL) and data line (SDA) are in high

state. The device enters the standby mode after a STOP condition

or after a programming cycle.

START Condition

High to low transition of SDA when SCL is high, preceding all

commands.

STOP Condition

Low to high transition of SDA when SCL is high, terminating all

communications. A STOP condition initiates an EEPROM

programming cycle. A STOP condition after reading a data byte

from the EEPROM initiates the Standby mode.

Acknowledge

A successful reception of eight data bits is indicated by the

receiver by pulling down the SDA line during the following clock

cycle of SCL (ACK). The transmitter on the other hand has to

release the SDA line after the transmission of eight data bits.

The EEPROM as the receiving device responds with an

acknowledge, when addressed. The master, on the other side,

acknowledges each data byte transmitted by the EEPROM and

can at any time end a read operation by releasing the SDA line (no

ACK) followed by a STOP condition.

Data Transfer

Data must change only during low SCL state, data remains valid

on the SDA bus during high SCL state. Nine clock pulses are

required to transfer one data byte, the most significant bit (MSB)

is transmitted first.

ACK

START Condition

Data allowed

STOP Condition

to Change

Acknowledge

SCL

SDA

IED02128

SLA24C01-S/P Folha de dados(PDF) 8 Page - Siemens Semiconductor Group

SLA24C01-S/P Folha de dados(HTML) 8 Page - Siemens Semiconductor Group

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Folha de dados Download

Ligação URL