HD64F2149YV datasheet(627/1075 Pages) RENESAS

627 / 1075 page

Section 18A Host Interface X-Bus Interface (XBS)

Rev. 3.00 Jan 18, 2006 page 599 of 1044

REJ09B0280-0300

18A.4 Interrupts

18A.4.1 IBF1, IBF2, IBF3, IBF4

The host interface can issue four interrupt requests to the slave processor: IBF1, IBF2, IBF3 and

IBF4. They are input buffer full interrupts for input data registers IDR1, IDR2, IDR3 and IDR4

respectively. Each interrupt is enabled when the corresponding enable bit is set.

Table 18A.9 Input Buffer Full Interrupts

Interrupt

Description

IBF1

Requested when IBFIE1 is set to 1 and IDR1 is full

IBF2

Requested when IBFIE2 is set to 1 and IDR2 is full

IBF3

Requested when IBFIE3 is set to 1 and IDR3 is full

IBF4

Requested when IBFIE4 is set to 1 and IDR4 is full

18A.4.2 HIRQ11, HIRQ1, HIRQ12, HIRQ3, and HIRQ4

Bits P45DR to P43DR in the port 4 data register (P4DR) and bits PB1ODR and PB0ODR in the

port B data register (PBODR) can be used as host interrupt request latches

The corresponding bits in P4DR are cleared to 0 by the host processor’s read signal (

IOR). If CS1

and HA0 are low, when

IOR goes low and the host reads ODR1, HIRQ1 and HIRQ12 are cleared

to 0. If

CS2 and HA0 are low, when IOR goes low and the host reads ODR2, HIRQ11 is cleared to

0. The corresponding bit in PBODR is cleared to 0 by the host’s read signal (

IOR). If CS3 and

HA0 are low, when

IOR goes low and the host reads ODR3, HIRQ3 is cleared to 0. If CS4 and

HA0 are low, when

IOR goes low and the host reads ODR4, HIRQ4 is cleared to 0. To generate a

host interrupt request, normally on-chip firmware writes 1 in the corresponding bit. In processing

the interrupt, the host’s interrupt handling routine reads the output data register (ODR1, ODR2,

ODR3, or ODR4) and this clears the host interrupt latch to 0.

Table 18A.10 indicates how these bits are set and cleared. Figure 18A.3 shows the processing in

flowchart form.

HD64F2149YV Folha de dados(PDF) 627 Page - Renesas Technology Corp