HD64F2149YV datasheet(425/1075 Pages) RENESAS

425 / 1075 page

Section 13 Timer Connection

Rev. 3.00 Jan 18, 2006 page 397 of 1044

REJ09B0280-0300

13.3.2

Clamp Waveform Generation (CL1/CL2/CL3 Signal Generation)

The timer connection facility and TMRX can be used to generate signals with different duty cycles

and rising/falling edges (clamp waveforms) in synchronization with the input signal (IHI signal).

Three clamp waveforms can be generated: the CL1, CL2, and CL3 signals. In addition, the CL4

signal can be generated using TMRY.

The CL1 signal rises simultaneously with the rise of the IHI signal, and when the CL1 signal is

high, the CL2 signal rises simultaneously with the fall of the IHI signal. The fall of both the CL1

and the CL2 signal can be specified by TCORA.

The rise of the CL3 signal can be specified as simultaneous with the sampling of the fall of the IHI

signal using the system clock, and the fall of the CL3 signal can be specified by TCORC.

TCNT in TMRX is set to count internal clock pulses and to be cleared on the rising edge of the

external reset signal (IHI signal). The CL3 signal can also fall when the IHI signal rises.

The value to be used as the CL1 signal pulse width is written in TCORA. Write a value of H'02 or

more in TCORA when internal clock

φ is selected as the TMRX counter clock, and a value or

H'01 or more when

φ/2 is selected. When internal clock φ is selected, the CL1 signal pulse width

is (TCORA set value + 3 ± 0.5). When the CL2 signal is used, the setting must be made so that

this pulse width is greater than the IHI signal pulse width.

The value to be used as the CL3 signal pulse width is written in TCORC. The TICR register in

TMRX captures the value of TCNT at the inverse of the external reset signal edge (in this case, the

falling edge of the IHI signal). The timing of the fall of the CL3 signal is determined by the sum of

the contents of TICR and TCORC. Caution is required if the rising edge of the IHI signal precedes

the fall timing set by the contents of TCORC, since the IHI signal will cause the CL3 signal to fall.

Examples of TMRX TCR settings are the same as those in table 13.3. The clamp waveform timing

charts are shown in figures 13.3 and 13.4.

Since the rise of the CL1 and CL2 signals is synchronized with the edge of the IHI signal, and

their fall is synchronized with the system clock, the pulse width variation is equivalent to the

resolution of the system clock.

Both the rise and the fall of the CL3 signal are synchronized with the system clock and the pulse

width is fixed, but there is a variation in the phase relationship with the IHI signal equivalent to

the resolution of the system clock.

HD64F2149YV Folha de dados(PDF) 425 Page - Renesas Technology Corp