PCIF0 datasheet(246/294 Pages) ATMEL

246 / 294 page

246

9219A–RFID–01/11

Atmel ATA5505 [Preliminary]

Figure 22-4. Programming the EEPROM Waveforms

22.7.6

Reading the Flash

The algorithm for reading the Flash memory is as follows (refer to “Programming the Flash” on

page 243 for details on Command and Address loading):

A: Load Command “0000 0010

b”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The Flash word low byte can now be read at DATA.

Set BS1 to “1”. The Flash word high byte can now be read at DATA.

Set OE to “1”.

22.7.7

Reading the EEPROM

The algorithm for reading the EEPROM memory is as follows (refer to “Programming the

Flash” on page 243 for details on Command and Address loading):

A: Load Command “0000 0011

b”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The EEPROM Data byte can now be read at DATA.

Set OE to “1”.

22.7.8

Programming the Fuse Low Bits

The algorithm for programming the Fuse Low bits is as follows (refer to “Programming the

Flash” on page 243 for details on Command and Data loading):

A: Load Command “0100 0000

b”.

C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit.

Give WR a negative pulse and wait for RDY/BSY to go high.

0x11

ADDR. HIGH

ADDR. LOW

DATA

ADDR. LOW

DATA

RDY/BSY

RESET +12V

DATA

XA1 / BS2

XA0

PAGEL / BS1

XTAL1

PCIF0 Folha de dados(PDF) 246 Page - ATMEL Corporation

PCIF0 Folha de dados(HTML) 246 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Folha de dados Download

Ligação URL