PCIF0 datasheet(144/294 Pages) ATMEL

144 / 294 page

144

9219A–RFID–01/11

Atmel ATA5505 [Preliminary]

The interconnection between Master and Slave CPUs with SPI is shown in Figure 13-2. The

system consists of two shift Registers, and a Master clock generator. The SPI Master initiates

the communication cycle when pulling low the Slave Select SS pin of the desired Slave. Mas-

ter and Slave prepare the data to be sent in their respective shift Registers, and the Master

generates the required clock pulses on the SCK line to interchange data. Data is always

shifted from Master to Slave on the Master Out – Slave In, MOSI, line, and from Slave to Mas-

ter on the Master In – Slave Out, MISO, line. After each data packet, the Master will

synchronize the Slave by pulling high the Slave Select, SS, line.

When configured as a Master, the SPI interface has no automatic control of the SS line. This

must be handled by user software before communication can start. When this is done, writing

a byte to the SPI Data Register starts the SPI clock generator, and the hardware shifts the

eight bits into the Slave. After shifting one byte, the SPI clock generator stops, setting the end

of transmission flag (SPIF). If the SPI Interrupt Enable bit (SPIE) in the SPCR Register is set,

an interrupt is requested. The Master may continue to shift the next byte by writing it into

SPDR, or signal the end of packet by pulling high the Slave Select, SS line. The last incoming

byte will be kept in the Buffer Register for later use.

When configured as a Slave, the SPI interface will remain sleeping with MISO tri-stated as

long as the SS pin is driven high. In this state, software may update the contents of the SPI

Data Register, SPDR, but the data will not be shifted out by incoming clock pulses on the SCK

pin until the SS pin is driven low. As one byte has been completely shifted, the end of trans-

mission flag, SPIF is set. If the SPI Interrupt Enable bit, SPIE, in the SPCR Register is set, an

interrupt is requested. The Slave may continue to place new data to be sent into SPDR before

reading the incoming data. The last incoming byte will be kept in the Buffer Register for later

use.

Figure 13-2. SPI Master-slave Interconnection

The system is single buffered in the transmit direction and double buffered in the receive direc-

tion. This means that bytes to be transmitted cannot be written to the SPI Data Register before

the entire shift cycle is completed. When receiving data, however, a received character must

be read from the SPI Data Register before the next character has been completely shifted in.

Otherwise, the first byte is lost.

In SPI Slave mode, the control logic will sample the incoming signal of the SCK pin. To ensure

correct sampling of the clock signal, the frequency of the SPI clock should never exceed

fclkio/4.

SHIFT

ENABLE

PCIF0 Folha de dados(PDF) 144 Page - ATMEL Corporation