Rev. 05.26.08

MTC600 Series

6 of 19

Embedded Power for

Business-Critical Continuity

Output - All Models (continued)

Electrical Specifications (continued)

General

Turn-on Time

4 seconds maximum

After power-on of the PM, the time for

autonomous outputs to reach regulation band

Early Power

Supported

PM supports Early Power requirements refer-

enced in MicroTCA.0 Rev 1.0 Section 4.4.11.1

Normal Power

Supported

PM supports Normal Power requirements refer-

enced in MicroTCA.0 Rev 1.0 Section 4.4.11.2

Autonomous Operation

Supported

PM supports Autonomous Operation require-

ments referenced in MicroTCA.0 Rev 1.0

Section 4.4.11.3

Diagnostic Mode

Supported

[GA2,GA1,GA0] = 101, or

[GA2,GA1,GA0] = 110

LED1 displays yellow

In Diagnostic Mode PM disables the IPMI con-

trols and slots are powered up based only on

PSI# signals

Hot-Swap Operation

(controlled)

Supported

Removal or addition of a PM will not cause a

fault or out-of-regulation condition

Hot-Swap Operation

(uncontrolled)

Supported

Removal or addition of a PM will not cause a

fault or out-of-regulation condition

Power Module Failover

Supported

When configured as a redundant PM, the PM

is capable of accepting the load of a failed PM

within specified voltage magnitude and timing

parameters

Fault Isolation

Supported

A fault in one PM will not cause the

shutdown of another PM

Note 7: All specifications in the redundancy sub-section assume the system is populated with Power Modules with the same

manufacturer's model numbers or otherwise compatible Power Modules. At the time of print, PICMG does not have a formal

methodology for verifying compatibility.