VSC8540RT datasheet(29/87 Pages) MICROCHIP

29 / 87 page

 2022 Microchip Technology Inc. and its subsidiaries

DS60001603E-page 29

VSC8540RT

When a PHY generates an interrupt, the MDINT pin is asserted by driving low if the interrupt pin enable bit (register

25.15) is set. The MDINT pin is configured for open-drain (active-low) operation. Tie the pin to a pull-up resistor to

VDDMDIO. The following illustration shows the configuration.

FIGURE 5-14:

MDINT CONFIGURED AS AN OPEN-DRAIN (ACTIVE-LOW) PIN

5.11

LED Interface

The LED interface supports direct drive and basic serial LED mode configuration. The polarity of the LED outputs is

programmable and can be changed using register 17E2, bits 13:10. The default polarity is active low.

Direct drive mode provides two LED signals, LED0 and LED1. The mode and function of each LED signal can be con-

figured independently.

In basic serial LED mode, all signals that can be displayed on LEDs are sent as LED_Data and LED_CLK for external

processing.

The following table shows the bit 9 settings for register 14G that are used to control the LED behavior for all the LEDs

in the VSC8540RT device.

5.11.1

LED MODES

Each LED pin can be configured to display different status information that can be selected by setting the LED mode in

The blink/pulse stretch is dependent on the LED behavior setting in register 30.

The following table provides a summary of the LED modes and functions. The modes listed are equivalent to the setting

used in register 29 to configure each LED pin.

TABLE 5-13:

LED DRIVE STATE

Setting

Active

Not Active

14G.9 = 1 (default)

Ground

Tristate

14G.9 = 0 (alternate setting) Ground

VDD

TABLE 5-14:

LED MODE AND FUNCTION SUMMARY

Mode

Function Name

LED State and Description

Link/Activity

1: No link in any speed on any media interface.

0: Valid link at any speed on any media interface.

Blink or pulse-stretch = Valid link at any speed on any media interface with activity

present.

Reserved

Reserved.

Link100/Activity

1: No link in 100BASE-TX.

0: Valid 100BASE-TX.

Blink or pulse-stretch = Valid 100BASE-TX link with activity present.

Link10/Activity

1: No link in 10BASE-T.

0: Valid 10BASE-T link.

Blink or pulse-stretch = Valid 10BASE-T link with activity present.

Reserved

Reserved.

MDINT

(to the Station

Manager)

Interrupt Pin Enable

(Register 25.15)

Interrupt Pin Status

(Register 26.15)

External Pull-Up

Resistor at the

Station Manager

VDDMDIO

PHY_n

MDINT

VSC8540RT Folha de dados(PDF) 29 Page - Microchip Technology

VSC8540RT Folha de dados(HTML) 29 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

Folha de dados Download

Ligação URL