CDCM7005_13 datasheet(30/45 Pages) TI

30 / 45 page

F0004-01

PLL

Out-of-Lock?

PLL-Lock

Output

Set?

3-State Charge-Pump

Reference Clock

Back?

64 PFD

Lock-Cycles

Yes

Charge-Pump is switched into 3-State.

P-divider and Yx output are at normal operation.

The Charge-Pump remains in 3-State

until the Reference Clock is back. The 1st

valid Reference Clock at the PFD releases

the Charge-Pump.

The PLL acquire 64 lock cycles to phase

align to the input clock.

Frequency Hold-Over Function works in

combination with the Analog Lock-Detect

function only!

Start

PLL is out-of-lock if the phase

difference of Reference Clock and

Feedback Clock at PFD are outside the

predefined Lock-Detect-Window or if a

frequency offset occurs.

PLL has to be in LOCK to start

HOLD-Function.

(The Analog Lock output is not reset by the first Out-of-

Lock event. It stays ‘High’ depending on the analog time

delay (output C-load). The time delay must be long enough

to assure proper HOLD function)

(The ‘PLL-Lock Output Set?’ enquiry can be bypassed by

setting the HOLDTR bit to [1] (Word 3, Bit 11)

CDCM7005

SCAS793E – JUNE 2005 – REVISED FEBRUARY 2013

www.ti.com

If logic low is applied to the HOLD pin, the charge pump will be switched to 3-state. After the HOLD pin is

released, the charge pump is switched back in to normal operation with the next valid reference clock cycle at

PRI_REF or SEC_REF and the next valid feedback clock cycle at the PFD. During HOLD, the P divider and all

outputs Yx are at normal operation.

HOLD-Over-Function: The PLL has to be in lock to start the HOLD function. It switches the charge pump in to 3-

State when an out-of-lock event occurs. It leaves the 3-state charge pump state when the reference clock is

back. Then it starts a locking sequence of 64 cycles before it goes back to the beginning of the HOLD-over loop.

The dedicated looking sequence and a digital phase alignment enable a fast lock.

Figure 22. Frequency HOLD-Over Function

Submit Documentation Feedback

Product Folder Links :CDCM7005

CDCM7005 Folha de dados(PDF) 30 Page - Texas Instruments

CDCM7005 Folha de dados(HTML) 30 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

Folha de dados Download

Ligação URL