HD64F2149YV datasheet(163/1075 Pages) RENESAS

Nome de Peças	HD64F2149YV

Descrição Electrónicos	Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2100 Series

PDF	1075 Pages

Scroll/Zoom	100%

Fabricante Electrônico	RENESAS [Renesas Technology Corp]

Página de início	http://www.renesas.com

Logo

163 / 1075 page

Section 5 Interrupt Controller

Rev. 3.00 Jan 18, 2006 page 135 of 1044

REJ09B0280-0300

5.6.2

Instructions that Disable Interrupts

Instructions that disable interrupts are LDC, ANDC, ORC, and XORC. After any of these

instructions is executed, all interrupts except NMI are disabled and the next instruction is always

executed. When the I bit or UI bit is set by one of these instructions, the new value becomes valid

two states after execution of the instruction ends.

5.6.3

Interrupts during Execution of EEPMOV Instruction

Interrupt operation differs between the EEPMOV.B instruction and the EEPMOV.W instruction.

With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer

is not accepted until the move is completed.

With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt

exception handling starts at a break in the transfer cycle. The PC value saved on the stack in this

case is the address of the next instruction.

Therefore, if an interrupt is generated during execution of an EEPMOV.W instruction, the

following coding should be used.

L1: EEPMOV.W

MOV.W

R4,R4

BNE

HD64F2149YV Folha de dados(PDF) 163 Page - Renesas Technology Corp