HD64F2149YV datasheet(493/1075 Pages) RENESAS

493 / 1075 page

Section 15 Serial Communication Interface (SCI, IrDA)

Rev. 3.00 Jan 18, 2006 page 465 of 1044

REJ09B0280-0300

In serial reception, the SCI operates as described below.

1. The SCI monitors the transmission line, and if a 0 stop bit is detected, performs internal

synchronization and starts reception.

2. The received data is stored in RSR in LSB-to-MSB order.

3. The parity bit and stop bit are received.

After receiving these bits, the SCI carries out the following checks.

a. Parity check:

The SCI checks whether the number of 1 bits in the receive data agrees with the parity

(even or odd) set in the O/

E bit in SMR.

b. Stop bit check:

The SCI checks whether the stop bit is 1.

If there are two stop bits, only the first is checked.

c. Status check:

The SCI checks whether the RDRF flag is 0, indicating that the receive data can be

transferred from RSR to RDR.

If all the above checks are passed, the RDRF flag is set to 1, and the receive data is stored in

RDR.

If a receive error* is detected in the error check, the operation is as shown in table 15.11.

Note: *

Subsequent receive operations cannot be performed when a receive error has occurred.

Also note that the RDRF flag is not set to 1 in reception, and so the error flags must be

cleared to 0.

4. If the RIE bit in SCR is set to 1 when the RDRF flag changes to 1, a receive-data-full interrupt

(RXI) request is generated.

Also, if the RIE bit in SCR is set to 1 when the ORER, PER, or FER flag changes to 1, a

receive-error interrupt (ERI) request is generated.

HD64F2149YV Folha de dados(PDF) 493 Page - Renesas Technology Corp