MS85RC1MTY(AEC-Q100 Compliant)

DS501-00095-0v1-E

5



DEVICE ADDRESS WORD (Slave address)

Following the start condition, the master inputs the 8 bits device address word to start I2C communication.

The device address word (8 bits) consists of a device Type code (4 bits), device address code (2 bits),

MSB(1bit) and a read/write code (1 bit).

• Device Type Code (4 bits)

The upper 4 bits of the device address word are a device type code that identifies the device type, and are

fixed at “1010” for the MS85RC1MTY.

• Device Address Code (2 bits)

Following the device type code, the 2 bits of the device address code are input in order of A2 and A1.

The device address code identifies one device from up to four devices connected to the bus.

Each MS85RC1MTY is given a unique 2 bits code on the device address pin (external hardware pin A2

and A1). The slave only responds if the received device address code is equal to this unique 3 bits code.

• The most significant address(1 bit)

The seventh bit of device address word is A16(1 bit) that is the most significant address.

• Read/Write Code (1 bit)

The 8th bit of the device address word is the R/W (read/write) code. When the R/W code is “0”, a write

operation is enabled, and the R/W code is “1”, a read operation is enabled for the MS85RC1MTY.

It turns to a stand-by state if the device code is not “1010” or device address code does not equal to pin A2,

A1 and A0.



Device Address Word

..

..

Start

1

2

34567891

2

SCL

SDA

ACK

A

S

S

10

1

0

A2

A1

A16 R/W

A

Access from master

Access from slave

Devide Code

Start Condition

ACK(SDA is the “L” level)

Devide Address Code

Read/Write Code

The most significant address