AT89C5132-ROTUL datasheet(152/181 Pages) ATMEL

152 / 181 page

152

4173D–USB–02/06

AT89C5132

22. Keyboard Interface

The AT89C5132 implements a keyboard interface allowing the connection of a 4 x n matrix key-

board. It is based on 4 inputs with programmable interrupt capability on both high or low level.

These inputs are available as alternate function of P1.3:0 and allow exit from idle and power

down modes.

22.1

Description

The keyboard interfaces with the C51 core through two special function registers: KBCON, the

keyboard control register (see Table 101); and KBSTA, the keyboard control and status register

(see Table 102).

The keyboard inputs are considered as 4 independent interrupt sources sharing the same inter-

rupt vector. An interrupt enable bit (EKB in IEN1 register) allows global enable or disable of the

keyboard interrupt (see Figure 22-1). As detailed in Figure 22-2 each keyboard input has the

capability to detect a programmable level according to KINL3:0 bit value in KBCON register.

Level detection is then reported in interrupt flags KINF3:0 in KBSTA register.

Any of the KINF3:0 flags can trigger a keyboard interrupt. To do so, corresponding mask bits

KINM3:0 in KBCON register must be cleared. The keyboard interrupt service routine is executed

each time an unmasked KINFx flag is set. The interrupt must be acknowledged by reading

KBSTA which automatically clears KINF3:0 flags.

This structure allows keyboard arrangement from 1 by n to 4 by n matrix and allow usage of KIN

inputs for any other purposes.

Figure 22-1. Keyboard Interface Block Diagram

Figure 22-2. Keyboard Input Circuitry

22.1.1

Power Reduction Mode

KIN3:0 inputs allow exit from idle and power down modes as detailed in Section “Power Man-

agement”, page 44. To enable this feature, KPDE bit in KBSTA register must be set to logic 1.

Due to the asynchronous keypad detection in power down mode (all clocks are stopped), exit

may happen on parasitic key press. In this case, no key is detected and software must enter

power-down again.

22.2

Registers

Table 101. KBCON Register

KIN0

Keyboard Interface

Interrupt Request

EKB

IEN1.4

Input Circuitry

KIN1

Input Circuitry

KIN2

Input Circuitry

KIN3

Input Circuitry

KIN3:0

KINM3:0

KBCON.3:0

KINF3:0

KBSTA.3:0

KINL3:0

KBCON.7:4

AT89C5132-ROTUL Folha de dados(PDF) 152 Page - ATMEL Corporation

AT89C5132-ROTUL Folha de dados(HTML) 152 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Folha de dados Download

Ligação URL