AT89C5132-ROTUL datasheet(53/181 Pages) ATMEL

53 / 181 page

4173D–USB–02/06

AT89C5132

12.4.1

Mode 0 (13-bit Timer)

Mode 0 configures Timer 1 as a 13-bit Timer, which is set up as an 8-bit Timer (TH1 register)

with a modulo-32 prescaler implemented with the lower 5 Bits of the TL1 register (see Figure 12-

2). The upper 3 Bits of TL1 register are ignored. Prescaler overflow increments TH1 register.

12.4.2

Mode 1 (16-bit Timer)

Mode 1 configures Timer 1 as a 16-bit Timer with TH1 and TL1 registers connected in cascade

(see Figure 12-4). The selected input increments TL1 register.

12.4.3

Mode 2 (8-bit Timer with

Auto-Reload)

Mode 2 configures Timer 1 as an 8-bit Timer (TL1 register) with automatic reload from TH1 reg-

ister on overflow (see Figure 12-6). TL1 overflow sets TF1 flag in TCON register and reloads

TL1 with the contents of TH1, which is preset by software. The reload leaves TH1 unchanged.

12.4.4

Mode 3 (Halt)

Placing Timer 1 in mode 3 causes it to halt and hold its count. This can be used to halt Timer 1

when TR1 run control bit is not available i.e. when Timer 0 is in mode 3.

12.5

Interrupt

Each Timer handles one interrupt source that is the timer overflow flag TF0 or TF1. This flag is

set every time an overflow occurs. Flags are cleared when vectoring to the Timer interrupt rou-

tine. Interrupts are enabled by setting ETx bit in IEN0 register. This assumes interrupts are

globally enabled by setting EA bit in IEN0 register.

Figure 12-10. Timer Interrupt System

TF0

TCON.5

ET0

IEN0.1

Timer 0

Interrupt Request

TF1

TCON.7

ET1

IEN0.3

Timer 1

Interrupt Request

AT89C5132-ROTUL Folha de dados(PDF) 53 Page - ATMEL Corporation