MPC7410EC datasheet(12/56 Pages) NXP

12 / 56 page

MPC7410 RISC Microprocessor Hardware Specifications, Rev. 6.1

Freescale Semiconductor

Electrical and Thermal Characteristics

High-Z (off-state) leakage current,

Vin = L2OVDD/OVDD

1.8

ITSI

—20

µA

2, 3,

5, 7

2.5

ITSI

—35

3.3

ITSI

—70

Output high voltage, IOH = –5 mA

1.8

VOH

(L2)OVDD – 0.45

—

2.5

VOH

1.7

—

3.3

VOH

2.4

—

Output low voltage, IOL = 5 mA

1.8

VOL

—0.45

2.5

VOL

—0.4

3.3

VOL

—0.4

Capacitance, Vin = 0 V, f = 1 MHz

Cin

—

6.0

3, 4, 7

Notes:

1. Nominal voltages; see Table 3 for recommended operating conditions.

2. For processor bus signals, the reference is OVDD while L2OVDD is the reference for the L2 bus signals.

3. Excludes factory test signals.

4. Capacitance is periodically sampled rather than 100% tested.

5. The leakage is measured for nominal OVDD and L2OVDD, or both OVDD and L2OVDD must vary in the same

direction (for example, both OVDD and L2OVDD vary by either +5% or –5%).

6. Measured at max OVDD/L2OVDD.

7. Excludes IEEE 1149.1 boundary scan (JTAG) signals.

8. For JTAG support: all signals controlled by BVSEL and L2VSEL will see VIL/VIH/VOL/VOH/CVIH/CVIL DC limits of

1.8 V mode while either the EXTEST or CLAMP instruction is loaded into the IEEE 1149.1 instruction register by

the UpdateIR TAP state until a different instruction is loaded into the instruction register by either another UpdateIR

or a Test-Logic-Reset TAP state. If only TSRT is asserted to the part, and then a SAMPLE instruction is executed,

there is no way to control or predict what the DC voltage limits are. If HRESET is asserted before executing a

SAMPLE instruction, the DC voltage limits will be controlled by the BVSEL/L2VSEL settings during HRESET.

Anytime HRESET is not asserted (that is, just asserting TRST), the voltage mode is not known until either EXTEST

or CLAMP is executed, at which time the voltage level will be at the DC limits of 1.8 V.

Table 5. DC Electrical Specifications (continued)

At recommended operating conditions (see Table 3)

Characteristic

Nominal

Bus

Voltage1

Symbol

Min

Max

Unit

Notes

MPC7410EC Folha de dados(PDF) 12 Page - NXP Semiconductors

MPC7410EC Folha de dados(HTML) 12 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Folha de dados Download

Ligação URL