MB90F548GPF datasheet(18/70 Pages) CYPRESS

18 / 70 page

Document Number: 002- 07696 Rev. *A

Page 18 of 70

MB90540G/545G Series

(6) Pull-up/down resistors

The MB90540G/545G Series does not support internal pull-up/down resistors (except Port0

 Port3 : pull-up resistors) . Use

external components where needed.

(7) Crystal Oscillator Circuit

Noises around X0 or X1 pins may be possible causes of abnormal operations. Make sure to provide bypass capacitors via the

shortest distances from X0, X1 pins, crystal oscillator (or ceramic resonator) and ground lines, and make sure, to the utmost effort,

that lines of oscillation circuits do not cross the lines of other circuits.

It is highly recommended to provide a printed circuit board artwork surrounding X0 and X1 pins with a ground area for stabilizing the

operation.

(8) Turning-on Sequence of Power Supply to A/D Converter and Analog Inputs

Make sure to turn on the A/D converter power supply (AVCC, AVRH, AVRL) and analog inputs (AN0 to AN7) after turning-on the

digital power supply (VCC) .

Turn-off the digital power after turning off the A/D converter supply and analog inputs. In this case, make sure that the voltage does

not exceed AVRH or AVCC (turning on/off the analog and digital power supplies simultaneously is acceptable) .

(9) Connection of Unused Pins of A/D Converter

Connect unused pins of A/D converter to AVCC

 V

, AVSS

 AVRH  V

(10) N.C. Pin

The N.C. (internally connected) pin must be opened for use.

(11) Notes on Energization

To prevent the internal regulator circuit from malfunctioning, set the voltage rise time during energization at 50

s or more (0.2 V to

2.7 V) .

MB90F548GPF Folha de dados(PDF) 18 Page - Cypress Semiconductor