ADA4177-2ARMZ-R7 datasheet(28/31 Pages) AD

28 / 31 page

ADA4177-1/ADA4177-2/ADA4177-4

Data Sheet

Figure 95. ADA4177-1/ADA4177-2/ADA4177-4 Used as a Comparator with

±5 V Supplies and a ±1 V Input Step, Voltage Follower Configuration

OUTPUT PHASE REVERSAL

Phase reversal is defined as a change in polarity in the amplifier

transfer function. Many op amps exhibit phase reversal when

the voltage applied to the input is greater than the maximum

common-mode voltage. In some instances, this phase reversal

can cause permanent damage to the amplifier. In feedback

loops, it can result in system lockups or equipment damage.

The ADA4177-1, ADA4177-2, and ADA4177-4 are immune to

phase reversal problems even at input voltages beyond the

power supply settings.

Figure 96. Output Showing No Phase Reversal in Overvoltage Condition

PROPER PRINTED CIRCUIT BOARD (PCB) LAYOUT

The ADA4177-1, ADA4177-2, and ADA4177-4 are high

precision devices. To ensure optimum performance at the PCB

level, take care in the design of the board layout.

To avoid leakage currents, maintain a clean and moisture free

board surface. Coating the surface creates a barrier to moisture

accumulation and reduces parasitic resistance on the board.

Keeping supply traces short and properly bypassing the power

supplies minimizes the power supply disturbances caused by

the output current variation, such as when driving an ac signal

into a heavy load. Connect bypass capacitors as closely as possible

to the device supply pins. Stray capacitances are a concern at the

outputs and the inputs of the amplifier. Keep the signal traces at

least 5 mm from supply lines to minimize coupling.

A variation in temperature across the PCB can cause a mismatch

in the Seebeck voltages at solder joints and other points where

dissimilar metals are in contact, resulting in thermal voltage errors.

To minimize these thermocouple effects, orient resistors so that

heat sources warm both ends equally. Ensure, where possible,

that input signal paths contain matching numbers and types of

components, to match the number and type of thermocouple

junctions. For example, dummy components such as zero value

resistors can be used to match real resistors in the opposite

input path. Place matching components in close proximity to

each other, and orient them in the same manner. Ensure that

leads are of equal length so that thermal conduction is in

equilibrium. Keep heat sources on the PCB as far away from

amplifier input circuitry as is practical.

The use of a ground plane is highly recommended. A ground

plane reduces EMI noise and maintains a constant temperature

across the circuit board.

Rev. C | Page 28 of 31

ADA4177-2ARMZ-R7 Folha de dados(PDF) 28 Page - Analog Devices

ADA4177-2ARMZ-R7 Folha de dados(HTML) 28 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Folha de dados Download

Ligação URL