OUT

ISO5451

Product

Folder

Sample &

Buy

Technical

Documents

Tools &

Software

Support &

Community

ISO5451

SLLSEO1B – JUNE 2015 – REVISED DECEMBER 2015

ISO5451 High-CMTI 2.5-A / 5-A Isolated IGBT, MOSFET Gate Driver

with Active Safety Features

1 Features

3 Description

1

•

50-kV/

μs Minimum and 100-kV/μs Typical

driver for IGBTs and MOSFETs with 2.5-A source

Common-Mode Transient Immunity (CMTI)

and 5-A sink current. The input side operates from a

single 3-V to 5.5-V supply. The output side allows for

•

2.5-A Peak Source and 5-A Peak Sink Currents

a supply range from minimum 15-V to maximum

30-V. Two complementary CMOS inputs control the

•

Short Propagation Delay: 76 ns (Typ),

output state of the gate driver. The short propagation

110 ns (Max)

time of 76 ns assures accurate control of the output

•

2-A Active Miller Clamp

stage.

•

Output Short-Circuit Clamp

An internal desaturation (DESAT) fault detection

•

Fault Alarm upon Desaturation Detection is

recognizes

when

the

IGBT

is

in

an

overload

Signaled on FLT and Reset Through RST

condition. Upon a DESAT detect the gate driver

•

Input and Output Under Voltage Lock-Out (UVLO)

with Ready (RDY) Pin Indication

immediately off.

•

Active Output Pull-down and Default Low Outputs

When desaturation is active, a fault signal is sent

with Low Supply or Floating Inputs

across the isolation barrier pulling the FLT output at

the input side low and blocking the isolator input. The

•

3-V to 5.5-V Input Supply Voltage

FLT output condition is latched and can be reset

•

15-V to 30-V Output Driver Supply Voltage

through a low-active pulse at the RST input.

•

CMOS Compatible Inputs

When the IGBT is turned off during normal operation

•

Rejects Input Pulses and Noise Transients

with bipolar output supply, the output is hard clamp to

Shorter Than 20 ns

•

Operating Temperature: –40°C to 125°C Ambient

clamp can be used, allowing Miller current to sink

across a low impedance path preventing IGBT to be

•

dynamically turned on during high voltage transient

•

Safety and Regulatory Certifications:

conditions.

–

Reinforced Isolation per DIN V VDE V 0884-10

Device Information(1)

(VDE V 0884-10):2006-12

PART NUMBER

PACKAGE

BODY SIZE (NOM)

–

ISO5451

SOIC (16)

10.30 mm × 7.50 mm

–

CSA Component Acceptance Notice 5A, IEC

(1) For all available packages, see the orderable addendum at

60950-1, IEC 60601-1 and IEC 61010-1 End

the end of the datasheet.

Equipment Standards

Functional Block Diagram

–

CQC Certification per GB4943.1-2011

–

All Certifications are Planned

2 Applications

•

Isolated IGBT and MOSFET Drives in

–

Industrial Motor Control Drives

–

Industrial Power Supplies

–

Solar Inverters

–

HEV and EV Power Modules

–

Induction Heating

1

An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,

intellectual property matters and other important disclaimers. PRODUCTION DATA.