24AA128EST datasheet(6/12 Pages) MICROCHIP

6 / 12 page

24AA128/24LC128

DS21191B-page 6

5.0

DEVICE ADDRESSING

A control byte is the ﬁrst byte received following the

start condition from the master device (Figure 5-1). The

control byte consists of a 4-bit control code; for the

24xx128 this is set as 1010 binary for read and write

operations. The next three bits of the control byte are

the chip select bits (A2, A1, A0). The chip select bits

allow the use of up to eight 24xx128 devices on the

same bus and are used to select which device is

accessed. The chip select bits in the control byte must

correspond to the logic levels on the corresponding A2,

A1, and A0 pins for the device to respond. These bits

are in effect the three most signiﬁcant bits of the word

address.

The last bit of the control byte deﬁnes the operation to

be performed. When set to a one a read operation is

selected, and when set to a zero a write operation is

selected. The next two bytes received deﬁne the

address of the ﬁrst data byte (Figure 5-2). Because

only A13…A0 are used, the upper two address bits are

don’t care bits. The upper address bits are transferred

ﬁrst, followed by the less signiﬁcant bits.

Following the start condition, the 24xx128 monitors the

SDA bus checking the device type identiﬁer being

transmitted. Upon receiving a 1010 code and appropri-

ate device select bits, the slave device outputs an

acknowledge signal on the SDA line. Depending on the

state of the R/W bit, the 24xx128 will select a read or

write operation.

FIGURE 5-1:

CONTROL BYTE FORMAT

5.1

Contiguous Addressing Across

Multiple Devices

The chip select bits A2, A1, A0 can be used to expand

the contiguous address space for up to 1 Mbit by add-

ing up to eight 24xx128's on the same bus. In this case,

software can use A0 of the control byte as address bit

A14; A1, as address bit A15; and A2, as address bit

A16. It is not possible to sequentially read across

device boundaries.

FIGURE 5-2:

ADDRESS SEQUENCE BIT ASSIGNMENTS

SACK

R/W

Control Code

Chip Select

Bits

Slave Address

Acknowledge Bit

Start Bit

Read/Write Bit

010

0 R/W

••

•

••

CONTROL BYTE

ADDRESS HIGH BYTE

ADDRESS LOW BYTE

CONTROL

CODE

CHIP

SELECT

BITS

X = Don’t Care Bit

24AA128EST Folha de dados(PDF) 6 Page - Microchip Technology

24AA128EST Folha de dados(HTML) 6 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Folha de dados Download

Ligação URL