| Os motores de busca de Datasheet de Componentes eletrônicos |
|
AN4121 Folha de dados(PDF) 9 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
AN4121 Folha de dados(HTML) 9 Page - STMicroelectronics |
|
9 / 26 page ![]() AN4121 Circuit description Doc ID 023243 Rev 1 9/26 In standalone operating mode these multipurpose pins output: ● negative power direction on SYN-NP pin; ● tamper condition detected on SDA-TD pin; ● no load condition detected on SCL-NLC pin. For this reason these pins are connected to the three LEDs, D9, D10 and D11. In this configuration, the LED pin outputs a pulse train with frequency proportional to the three-phase power and it is connected to LED D12. When configured in peripheral operating mode, the SPI port is enabled and some microcontroller based applications can either read internal data records or write the mode and configuration signals by means of dedicated protocol, or reset the device. By default, the STPMC1 is configured in peripheral mode (configuration bits APL=0). This also implies the following output settings: ● watchdog reset signal on MON pin; ● zero-crossing (ZCR) on MOP pin; ● programmable energy pulsed output on LED pin. For further information on STPMC1 programmable bit settings, please refer to the datasheet. The STPMC1 SPI protocol is explained in detail in a related application note. Connector P1 is also used in the demonstration phase to connect the measurement module to a PC through the STPM parallel programmer/reader hardware interface. This allows the user to set temporary and/or permanently the internal STPMC1 registers using a dedicated GUI. The VOTP pin on the connector P1 is used when a host wants to permanently write some configuration bits in the STPMC1 device. In this case, a +15 V power level must be present on the VOTP. This level must be delivered from the host itself because the module does not have an onboard charge pump. Table 6. P1 connector pin description Pin Pin name Functional description 1. VOTP Power supply input of +15.0 V during permanent write to OTP cells 2. --- Not connected 3. GND Signal reference level 0 V and power supply return 4. SDA-TD SPI interface data 5. SCS SPI interface enable 6. SCL-NLC SPI interface clock 7. --- Not connected 8. SYN-NP SPI interface signal 9. --- Not connected 10. VCC Power-out of +3.3 or 5 V |
|
Ligação URL |
| ALLDATASHEET é útil para você? [ DONATE ] |
Sobre Alldatasheet | Publicidade | Contato conosco | Privacy Policy | Link para a ficha técnica | roca de Link | Lista de Fabricantes All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |