LCL8052ACPD datasheet(15/21 Pages) INTERSIL

15 / 21 page

5-20

Detailed Description

DIGITAL SECTION

The digital section includes the clock oscillator circuit, a

16-bit or 14-bit binary counter with output latches and TTL-

compatible three-state output drivers, polarity, over-range

and control logic and UART handshake logic, as shown in

the Block Diagram Figure 9 (16-bit version shown).

Throughout this description, logic levels will be referred to as

“low” or “high”. The actual logic levels are deﬁned under

“ICL7104 Electrical Speciﬁcation”. For minimum power con-

sumption, all inputs should swing from GND (low) to V+

(high). Inputs driven from TTL gates should have 3 - 5k

Ω

pullup resistors added for maximum noise immunity.

MODE Input

The MODE input is used to control the output mode of the

converter. When the MODE pin is connected to GND or left

open (this input is provided with a pulldown resistor to

ensure a low level when the pin is left open), the converter is

in its “Direct” output mode, where the output data is directly

accessible under the control of the chip and byte enable

inputs. When the MODE input is pulsed high, the converter

enters the UART handshake mode and outputs the data in

three bytes for the 7104-16 or two bytes for the 7104-14 then

returns to “direct” mode. When the MODE input is left high,

the converter will output data in the handshake mode at the

end of every conversion cycle. (See section entitled “Hand-

shake Mode” for further details).

STATUS Output

During a conversion cycle, the STATUS output goes high at

the beginning of Input Integrate (Phase II), and goes low

one-half clock period after new data from the conversion has

been stored in the output latches. See Figure 8 for details of

this timing. This signal may be used as a “data valid” ﬂag

(data never changes while STATUS is low) to drive inter-

rupts, or for monitoring the status of the converter.

TABLE 5. THREE-STATE BYTE FORMATS AND ENABLE PINS

CE/LD

HBEN

MBEN

LBEN

ICL7104-16

POL

O/R

B16

B15

B14

B13

B12

B11

B10

HBEN

LBEN

ICL7104-14

POL

O/R

B14

B13

B12

B11

B10

FIGURE 9. DIGITAL SECTION

HBEN

MBEN

LBEN

CE/LD

OSCILLATOR

SEND

MODE

CLOCK

STATUS

R/H

(2)

(3)

AND CLOCK

CIRCUITRY

18/16 THREE-STATE OUTPUTS

18/16 LATCHES

18/16 BIT COUNTER

LATCH

CLOCK

HANDSHAKE

LOGIC

(-16 ONLY)

CONVERSION

CONTROL

LOGIC

INITIAL

CLEAR

CLOCK

(1)

COMP OUT

INT

DEINT(+)

DEINT(-)

ANALOG

SECTION

ICL8052/ICL7104, ICL8068/ICL7104

LCL8052ACPD Folha de dados(PDF) 15 Page - Intersil Corporation

LCL8052ACPD Folha de dados(HTML) 15 Page - Intersil Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Folha de dados Download

Ligação URL