5

sPrecautions

Recommended Mounting of MS-156C coaxial switch

on the PCB during the manufacturing process

MS-156C

To avoid contamination when cutting-off,

do not place PCB bridge close to the

mounted MS-156C.

1. This product is intended to be used for circuit inspection only. Consult us if any other application is

considered.

2. Cross-hatched area shown on the PCB mounting pattern must be free of any conducive traces. Placing

conductive traces in this area may affect performance and will void product warranties.

When the bottom surface of the product (i.e., the

shaded area of the specified land dimensions

diagram on the previous page) has been processed with a susbtrate copper trace and resist processing,

Hirose Electric will not be able to warrant the product.

3. Do not use hand soldering for mounting of MS-156C.

Doing so could result in solder and flux wicking to the contact areas.

4. Exercise caution as not to allow any debris to enter the board mounted MS-156C when cutting PCB.

5. Do not use the washing process.

6. Please refrain from using the product in environments specifically affected by excessive vibration, shock,

dust, high humidity, gases, very high temperatures and very low temperatures such as outdoor

equipment. It might cause degradation or destruction of the product.Even if it endures during a short time,

long time quarification is not quaranteed.

7. For use of this product, be sure to put contact area of plug on position P(P4 full view) perpendicularly.

8. Plugs can be roughly classified to two types.

- For mass production line automatic check (Press down type)

- For manual check (With retentive lock) : Unable to be used at production line.

9. When automatic inspections are to be performed during the manufacturing operations, request the MS-

156 plug connector manual for examples of implementation.

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.