WM8782

Production Data

w

PD, April 2010, Rev 4.7

12

DIGITAL AUDIO INTERFACE

The digital audio interface uses three pins:



DOUT: ADC data output



LRCLK: ADC data alignment clock



BCLK: Bit clock, for synchronisation

The digital audio interface takes the data from the internal ADC digital filters and places it on DOUT

and LRCLK. DOUT is the formatted digital audio data stream output from the ADC digital filters with

left and right channels multiplexed together. LRCLK is an alignment clock that controls whether Left

or Right channel data is present on the DOUT line. DOUT and LRCLK are synchronous with the

BCLK signal with each data bit transition signified by a BCLK high to low transition. DOUT is always

an output. BCLK and LRCLK maybe an inputs or outputs depending whether the device is in Master

or Slave mode. (see Master and Slave Mode Operation, below).

Three different audio data formats are supported:



Left justified



Right justified



I

MASTER AND SLAVE MODE OPERATION

The WM8782 can be configured as either a master or slave mode device. As a master device the

WM8782 generates BCLK and LRCLK and thus controls sequencing of the data transfer on DOUT. In

slave mode, the WM8782 responds with data to clocks it receives over the digital audio interface. The

mode can be selected by setting the MS input pin (see Table 6 Master/Slave selection below).

Master and slave modes are illustrated below.

Figure 6 Master Mode

Figure 7 Slave Mode

PIN

DESCRIPTION

M/S

Master/Slave Selection

0 = Slave Mode

1= Master Mode

Table 6 Master/Slave selection

AUDIO INTERFACE CONTROL

The Input Word Length and Audio Format mode can be selected by using IWL and FORMAT pins.

PIN

DESCRIPTION

IWL

Word Length

0 = 16 bit

1 = 20 bit

Z = 24 bit

FORMAT

Audio Mode Select

0 = RJ

1 = LJ

Z = I2S

Table 7 Audio Data Format Control