0.155 (3.94)

0.955 (24.26)

0.040 dia

(1.02)

0.000

0.555 (14.1)

1.115 (28.32)

1

2

4

5

*Flanged case: Designator “F” required in Case Option position of model number.

BOTTOM VIEW CASE K4

0.162 dia

(4.11)

Squared corner and dot on top

of case indicate pin one.

3

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device.

Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.

Case K4, Rev E - 20100211

Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,

but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make

changes in products or specifications without notice.

Copyright © 1999-2010 Interpoint Corp. All rights reserved.

Flange Thickness: 0.067 +0.005/-0.007 (1.70 +0.13/-0.8)

2.910 max

(73.91)

Solder Seal

Solder Tip-off

FM-461, FMA-461

AND FMB-461

1.75 To 5 AMP

Page 7 of 9

FM/A/B Rev C 20100212

www.interpoint.com