0.160 (4.06)

0.960 (24.38)

Solder Seal

Solder Tip-off

0.040 dia

(1.02)

0.000

0.560 (14.22)

1.120 (28.45)

1

2

4

5

BOTTOM VIEW CASE H5

Squared corner and dot on top

of case indicate pin one.

3

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device.

Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.

Materials

Header

Cold Rolled Steel/Nickel/Tin

Cover

Cold Rolled Steel/Nickel/Tin

Pins

#52 alloy, compression glass seal

Case H5, Rev C - 20100211

Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,

but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make

changes in products or specifications without notice.

Copyright © 1999-2010 Interpoint Corp. All rights reserved.

FM-461, FMA-461

AND FMB-461

1.75 To 5 AMP

Page 6 of 9

FM/A/B Rev C 20100212

www.interpoint.com