S12CPUV2 datasheet(68/138 Pages) MOTOROLA

68 / 138 page

MC9S12DT128 Device User Guide — V02.09

2.3.21 PH6 / KWH6 — Port H I/O Pin 6

PH6 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode.

2.3.22 PH5 / KWH5 — Port H I/O Pin 5

PH5 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode.

2.3.23 PH4 / KWH4 — Port H I/O Pin 2

PH4 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode.

2.3.24 PH3 / KWH3 / SS1 — Port H I/O Pin 3

PH3 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode. It can be configured as slave select pin SS of the Serial Peripheral Interface

1 (SPI1).

2.3.25 PH2 / KWH2 / SCK1 — Port H I/O Pin 2

PH2 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode. It can be configured as serial clock pin SCK of the Serial Peripheral Interface

1 (SPI1).

2.3.26 PH1 / KWH1 / MOSI1 — Port H I/O Pin 1

PH1 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode. It can be configured as master output (during master mode) or slave input

pin (during slave mode) MOSI of the Serial Peripheral Interface 1 (SPI1).

2.3.27 PH0 / KWH0 / MISO1 — Port H I/O Pin 0

PH0 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode. It can be configured as master input (during master mode) or slave output

(during slave mode) pin MISO of the Serial Peripheral Interface 1 (SPI1).

2.3.28 PJ7 / KWJ7 / TXCAN4 / SCL / TXCAN0 — PORT J I/O Pin 7

PJ7 is a general purpose input or output pin. It can be configured to generate an interrupt causing the MCU

to exit STOP or WAIT mode. It can be configured as the transmit pin TXCAN for the Motorola Scalable

Controller Area Network controller 0 or 4 (CAN0, CAN4) or the serial clock pin SCL of the IIC module.

S12CPUV2 Folha de dados(PDF) 68 Page - Motorola, Inc