HD404618TF datasheet(19/91 Pages) RENESAS

19 / 91 page

HD404618 Series

Interrupts

The MCU has six interrupt sources: two external signals (

INT

0 and INT1), three timer/counters (timers A,

B, and C), and serial interface (serial).

An interrupt request flag (IF), interrupt mask (IM), and vector address are provided for each interrupt

source, and an interrupt enable flag (IE) controls the entire interrupt process.

Interrupt Control Bits and Interrupt Servicing: Locations $000 through $003 in RAM space are

reserved for interrupt control bits which can be accessed by RAM bit manipulation instructions.

The interrupt request flag (IF) cannot be set by software. MCU reset initializes the interrupt enable flag

(IE) and the IF to 0 and the interrupt mask (IM) to 1.

Figure 7 is a block diagram of the interrupt control circuit. Table 2 lists interrupt priorities and vector

addresses, and table 3 lists the interrupt processing conditions for the six interrupt sources.

An interrupt request occurs when the IF is set to 1 and IM to 0. If the IE is 1 at that point, the interrupt is

processed. A priority programmable logic array (PLA) generates the vector address assigned to that

interrupt source.

Figure 8 shows the interrupt processing sequence, and figure 9 shows an interrupt processing flowchart.

After an interrupt is acknowledged, the previous instruction is completed in the first cycle. The IE is reset

in the second cycle, the carry flag, status flag, and program counter values are pushed onto the stack during

the second and third cycles, and the program jumps to the vector address to execute the instruction in the

third cycle.

Program the JMPL instruction at each vector address to branch the program to the start address of the

interrupt program, and reset the IF by a software instruction within the interrupt program.

HD404618TF Folha de dados(PDF) 19 Page - Renesas Technology Corp