19

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

dry by connecting to the blower unit and use it to force air through the tube until

dry.

c. HEPA filter and pre-filter: Open the filter canister and inspect the filters.

Replace if excessively dirty.

STORAGE

If the blower will not be used for an extended period, remove the filter and battery

and store them in a clean, dry, cool place free of solvent-based vapours.

TROUBLESHOOTING

Use the table below to help identify possible causes and corrective action for

problems you may experience.

Fault

Possible solution

Blower does not supply air to the

hood

1. Press ON to start blower

2. Recharge battery

3. Verify battery is correctly connected to the

blower

4. Remove any blockage from blower outlet and

breathing tube.

Battery pack charge last less than

expected

1. Ensure battery pack is fully charged

2. Replace battery

3. Replace charger

4. Check the air filter (HEPA and pre-filter) and

replace if necessary

Blower cannot be turned off

Press ON/OFF button for one second

Battery RED level light is flashing Charge or replace battery

Danger light is on. alarm sounds

or blower vibrates.

Check the blower air flow as in PageXXX