6

MAINTENANCE

CHECKING /MAINTAINING THE OIL LEVEL

If the jack has been stored for long periods, check for oil leaks before use. If

necessary, check the oil level as follows:

1. Ensure the jack is fully lowered by

turning the control valve fully anti-

clockwise.

2. Remove the retaining screws and lift

off the cover plate.

3. Remove the filler plug.

• The oil should be almost level with

the bottom of the oil filler hole.

• Oil can be topped up using Clarke

Hydraulic Oil (p/n 3050830 1 litre).

4. Purge any air from the system and replace the filler plug and cover plate.

5. Dispose of any old/spilled oil appropriately and wipe up any spillage.

GENERAL CARE

1. Occasionally lubricate the hinges,

front wheels & rear castors with light

oil to inhibit corrosion. A grease

nipple is found on the main cross

shaft for occasional introduction of

grease.

2. Store in a dry location.

3. In the event of damaged

components, replacements are

available from Clarke Parts & Service.