5

OPERATION

This jack incorporates a twin piston pump with a ‘quick lift’ facility to provide rapid

raising of the unladen jack. When the jack encounters a load (the vehicle), its

distance raised per stroke reduces to provide gradual lifting

Before use, inspect the jack for oil leaks or any other sign of damage. Should any be

apparent, have the jack repaired by a qualified technician.

1. Ensure the vehicle to be raised is stable and on firm level ground with the wheels

chocked.

2. Position the jack so that the saddle is directly beneath the lifting point.

• Consult the vehicle handbook to determine suitable lifting points.

3. Twist the handle clockwise to close the control valve.

4. Pump the handle to raise the saddle until it reaches the jacking point.

5. Make sure that the saddle is in full contact with the lifting point and that there is

nothing that will prevent a clean lift. Keep all personnel at a safe distance before

lifting the vehicle.

6. Position axle stands directly beneath suitable supporting points on the vehicle and

very gently twist the handle anti-clockwise.

7. This will open the control valve to lower the load onto the stands.

• Make sure that the axle stands are in good condition and that they can

hold the load. Axle stands must be on a firm, level surface.

8. Ensure that the axle stands cannot move when supporting the load. Use suitable

wheel chocks to stop the vehicle from moving.

NOTE: The jack may move slightly during operation. It is important therefore,

that the floor is clean and completely free from debris.

9. To stop it lowering at any point, turn the handle clockwise again. Always avoid a

rapid descent by turning the handle slowly.

10. Carefully lower the vehicle onto the axle stand, checking constantly, preferably

with an assistant, that the vehicles jacking point rests snugly and cleanly on the

axle stand & the stand is stable before the weight is taken.

• Ensure this operation is carried out under complete control. DO NOT allow

the load to drop suddenly as this could damage internal parts.

11. Completely remove the jack from the vehicle.

WARNING: NEVER WORK ON A VEHICLE WHEN SUPPORTED ONLY

BY A JACK. THIS IS HIGHLY DANGEROUS. THE VEHICLE MUST BE

SUPPORTED ON AXLE STANDS OR SUITABLE SUPPORTS BENEATH

THE CORRECT JACKING/SUPPORT POINTS.