20

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ERROR MESSAGES

1. E01 Display + ERROR LED lit: Reverse connection

2. E02 Display + ERROR LED lit: Temperature in charger is too high

3. E03 Display + ERROR LED lit: The battery cannot store electric charge (dead

battery)

4. E04 Display + ERROR LED lit: No battery connected/battery voltage is lower

than 1 volt (dead battery)

5. REPAIR-ON displayed + REPAIR LED flashing: Charger automatically enters

repairing mode

6. REPAIR-ON displayed + REPAIR LED solid lit: Manually choose repairing

mode

TROUBLESHOOTING

Problem

Cause

Solution

Battery

does not

charge

Lack of AC input

power.

Make sure that the electrical circuit the

charger is on has power.

Faulty connections to

battery terminals.

Check the battery connections; ensure

that there is a good connection at the

battery terminal/post and/or vehicle

chassis.

Wrong charge

voltage selection.

Check that the correct charge voltage

was selected for the battery being

charged.

Battery voltage too

low.

Ensure enough charging time was

allowed to charge battery.

Charging a very cold

battery.

If the battery being charged is extremely

cold (below freezing), it will not accept a

high rate of charge, so the initial charge

rate will be slow.

The rate of charge will increase as the

battery warms.

NEVER attempt to charge a frozen

battery.