4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY

REMOVE THE STANDARD MANIFOLD

1. Loosen the hose clamp on the

blasting hose and pull the hose off

of the connector.

2. Unscrew the air hose from the

manifold.

3. Unscrew the manifold from the

tank.

FIT THE SODA BLASTING MANIFOLD

NOTE: Use PTFE tape on threaded connections for an air tight seal.

1. Screw the new manifold onto the

tank until tight, (use a spanner).

• Make sure that the air hose

connection faces the back of

the tank.

2. Screw in the air hose and tighten

with a spanner.

3. Push the blasting hose onto the

lower connector, tighten the

clamp with a flat head

screwdriver.

4. if the exhaust hose is not

connected push it onto the

remaining connector.

5. Tighten any hose clips.

WARNING: BEFORE OPERATING THE UNIT ENSURE YOU READ,

UNDERSTAND AND APPLY ALL SAFETY INSTRUCTIONS.