TSC2014IYZGR datasheet(14/62 Pages) TI2

14 / 62 page

X plate

Position

POSITION

TOUCH

Y plate

4096

Position

TOUCH

X plate

4096

ConductiveBar

InsulatingMaterial(Glass)

Silver

Ink

TransparentConductor(ITO)

BottomSide

Transparent

Conductor(ITO)

TopSide

X+

X-

Y+

Y-

ITO=IndiumTinOxide

TSC2014

SBAS484B – SEPTEMBER 2010 – REVISED DECEMBER 2016

www.ti.com

Product Folder Links: TSC2014

Submit Documentation Feedback

Feature Description (continued)

7.3.2 4-Wire Touch Screen Coordinate Pair Measurement

A 4-wire touch screen is typically constructed as shown in Figure 16. It consists of two transparent resistive

layers separated by insulating spacers.

Figure 16. 4-Wire Touch Screen Construction

The 4-wire touch screen panel works by applying a voltage across the vertical or horizontal resistive network.

The A/D converter converts the voltage measured at the point where the panel is touched. A measurement of the

Y position of the pointing device is made by connecting the X+ input to a data converter chip, turning on the Y+

and Y– drivers, and digitizing the voltage seen at the X+ input. The voltage measured is determined by the

voltage divider developed at the point of touch. For this measurement, the horizontal panel resistance in the X+

lead does not affect the conversion because of the high input impedance of the A/D converter.

Voltage is then applied to the other axis, and the A/D converter converts the voltage representing the X position

on the screen. This process provides the X and Y coordinates to the associated processor.

Measuring touch pressure (Z) can also be done with the TSC2014. To determine pen or finger touch, the

pressure of the touch must be determined. Generally, it is not necessary to have very high performance for this

test; therefore, 10-bit resolution mode is recommended (however, data sheet calculations are shown using the

12-bit resolution mode). There are several different ways of performing this measurement. The TSC2014

supports two methods. The first method requires knowing the X-plate resistance, the measurement of the X-

Position, and two additional cross panel measurements (Z2 and Z1) of the touch screen (see Figure 17).

Equation 1 calculates the touch resistance:

(1)

The second method requires knowing both the X-plate and Y-plate resistance, measurement of X-Position and

Y-Position, and Z1. Equation 2 also calculates the touch resistance:

(2)

TSC2014IYZGR Folha de dados(PDF) 14 Page - Texas Instruments

TSC2014IYZGR Folha de dados(HTML) 14 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Folha de dados Download

Ligação URL