WM8782

Product Preview

w

PP, May 2004, Rev 1.0

10

DEVICE DESCRIPTION

INTRODUCTION

The WM8782 is a stereo 24-bit ADC designed for demanding recording applications such as DVD

recorders, studio mixers, PVRs, and AV amplifiers. The WM8782 consists of stereo line level inputs,

followed by a sigma-delta modulator and digital filtering.

The device offers stereo line level inputs along with two control input pins (FORMAT, IWL) to allow

operation of the audio interface in three industry standard modes (left justified, right justified or I

An internal op-amp is integrated on the front end of the chip to accommodate analogue input signals

The WM8782 offers Master or Slave mode clocking schemes. A control input pin M/S is used to allow

Slave mode or Master mode operation. The WM8782 supports master clock rates from 128fs to

768fs and digital audio output word lengths from 16-24 bits. Sampling rates from 8kHz to 192kHz are

supported, delivering high SNR operating with 128x, 64x or 32x over-sampling, according to the

sample rate.

ADC

The WM8782 uses a multi-bit over sampled sigma-delta ADC. A single channel of the ADC is

illustrated in Figure 4 Multi-Bit Oversampling Sigma Delta ADC Schematic.

LIN/RIN

ANALOG

INTEGRATOR

MULTI

BITS

TO ADC DIGITAL FILTERS

Figure 4 Multi-Bit Oversampling Sigma Delta ADC Schematic

The use of multi-bit feedback and high oversampling rates reduces the effects of jitter and high

frequency noise.

The ADC Full Scale input is 1.0V rms at AVDD = 5.0 volts. Any voltage greater than full scale will

possibly overload the ADC and cause distortion. Note that the full scale input has a linear relationship

with AVDD. The internal op-amp and appropriate resistors can be used to reduce signals greater

than 1Vrms before they reach the ADC.

The ADC filters perform true 24 bit signal processing to convert the raw multi-bit oversampled data

from the ADC to the correct sampling frequency to be output on the digital audio interface.

ADC DIGITAL FILTER

The ADC digital filters contain a digital high pass filter. The high-pass filter response detailed in

Digital Filter Characteristics. The operation of the high pass filter removes residual DC offsets that

are present on the audio signal.