EC5741 datasheet(3/15 Pages) E-CMOS

3 / 15 page

Super Low Power, CMOS,

Rail-to-Rail Operational Amplifier

EC5741

E-CMOS Corp. (www.ecmos.com.tw)

3L03N-Rev.P001

Page 3 of 15

Operating Voltage

EC5741 series operate under wide input supply voltage (1.4V to 5.5V). In addition, all temperature

specifications apply from -40℃ to +125℃. Most behavior remains unchanged throughout the full operating

voltage range. These guarantees ensure operation throughout the single Li-Ion battery lifetime.

Rail-to-Rail Input

The input common-mode range of EC5741 series extends 100mV beyond the supply rails (VSS-0.1V to

VDD+0.1V). This is achieved by using complementary input stage. For normal operation, inputs should be

limited to this range.

Rail-to-Rail Output

Rail-to-Rail output swing provides maximum possible dynamic range at the output. This is particularly

important when operating in low supply voltages. The output voltage of EC5741 series can typically swing to

less than 10mV from supply rail in

light resistive loads (>100kΩ), and 60mV of supply rail in moderate resistive

loads (10kΩ).

Capacitive Load Tolerance

The EC5741 series can directly drive 250pF capacitive load in unity-gain without oscillation. Increasing the

gain enhances the

amplifier’s ability to drive greater capacitive loads. In unity-gain configurations, the

capacitive load drive can be improved by inserting an isolation resistor RISO in series with the capacitive load,

as shown in Figure 2.

Figure 2. Indirectly Driving a Capacitive Load Using Isolation Resistor

The bigger the RISO resistor value, the more stable VOUT will be. However, if there is a resistive load RL in

parallel with the capacitive load, a voltage divider (proportional to RISO/RL) is formed, this will result in a gain

error.

The circuit in Figure 3 is an improvement to the one in Figure 2. RF provides the DC accuracy by feed-forward

the VIN to RL. CF and RISO serve to counteract the loss of phase margin by feeding the high frequency

component of the output signal back to the

amplifier’s inverting input, thereby preserving the phase margin in

the overall feedback loop. Capacitive drive can be increased by increasing the value of CF. This in turn will

slow down the pulse response.

EC5741 Folha de dados(PDF) 3 Page - E-CMOS Corporation