3

© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com C1081_C0G_HV_FT_AUTO_SMD • 2/29/2016

Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)

High Voltage with Flexible Termination System (HV FT-CAP), C0G Dielectric, 500 – 3,000 VDC (Automotive Grade)

Automotive C-Spec Information

KEMET Automotive Grade products meet or exceed the requirements outlined by the Automotive Electronics Council. Details regarding

test methods and conditions are referenced in document AEC–Q200, Stress Test Qualification for Passive Components. These

products are supported by a Product Change Notification (PCN) and Production Part Approval Process warrant (PPAP).

Automotive products offered through our distribution channel have been assigned an inclusive ordering code C-Spec, "AUTO". This

C-Spec was developed in order to better serve small and medium sized companies that prefer an automotive grade component without

the requirement to submit a customer Source Controlled Drawing (SCD) or specification for review by a KEMET engineering specialist.

This C-Spec is therefore not intended for use by KEMET’s OEM Automotive customers and are not granted the same “privileges” as

other automotive C-Specs. Customer PCN approval and PPAP request levels are limited (see details below).

Product Change Notification (PCN)

The KEMET Product Change Notification system is used to communicate primarily the following types of changes:

• Product/process changes that affect product form, fit , function, and /or reliability

• Changes in manufacturing site

• Product obsolescence

KEMET Automotive

C-Spec

Customer Notification due to:

Days prior to

implementation

Process/Product change

Obsolescence*

Yes (with approval and

sign off)

Yes

180 days Minimum

AUTO

Yes (without approval)

Yes

90 days Minimum

1

KEMET assigned C-Specs require the submittal of a customer SCD or customer specification for review. For additional information contact KEMET.

Production Part Approval Process (PPAP)

The purpose of the Production Part Approval Process is:

• To ensure that supplier can meet the manufacturability and quality requirements for the purchased parts.

• To provide the evidence that all customer engineering design record and specification requirements are properly understood and

fulfilled by the manufacturing organization.

• To demonstrate that the established manufacturing process has the potential to produce the part

KEMET

Automotive

C-Spec

PPAP (Product Part Approval Process) Level

1

2

3

4

5

KEMET

●

●

●

●

●

AUTO

○

○

1

KEMET assigned C-Specs require the submittal of a customer SCD or customer specification for review. For additional information contact KEMET.

● Part Number specific PPAP available

○ Product family PPAP only