STM32F098VC datasheet(41/128 Pages) STMICROELECTRONICS

41 / 128 page

DocID026967 Rev 4

41/128

STM32F098CC STM32F098RC STM32F098VC

Pinouts and pin descriptions

VSS

Ground

100 E4

VDD

Digital power supply

1. PC13, PC14 and PC15 are supplied through the power switch. Since the switch only sinks a limited amount of current

(3 mA), the use of GPIOs PC13 to PC15 in output mode is limited:

- The speed should not exceed 2 MHz with a maximum load of 30 pF.

- These GPIOs must not be used as current sources (e.g. to drive an LED).

2. After the first RTC domain power-up, PC13, PC14 and PC15 operate as GPIOs. Their function then depends on the content

of the RTC registers which are not reset by the system reset. For details on how to manage these GPIOs, refer to the RTC

domain and RTC register descriptions in the reference manual.

3. This pin is powered by VDDA.

4. PC6, PC7, PC8, PC9, PA8, PA9, PA10, PA11, PA12, PA13, PF6, PA14, PA15, PC10, PC11, PC12, PD0, PD1 and PD2 I/Os

are supplied by VDDIO2

5. After reset, these pins are configured as SWDIO and SWCLK alternate functions, and the internal pull-up on the SWDIO pin

and the internal pull-down on the SWCLK pin are activated.

Table 12. STM32F098CC/RC/VC pin definitions (continued)

Pin numbers

Pin name

(function upon

reset)

Pin functions

Alternate functions

Additional

functions

STM32F098VC Folha de dados(PDF) 41 Page - STMicroelectronics