STCC5021 datasheet(14/37 Pages) STMICROELECTRONICS

14 / 37 page

Application information

STCC5011, STCC5021

14/37

DocID024660 Rev 6

5.2

Remote wakeup in S3

For more information refer to Section 5.4: State machine.

If the CTLx pins are controlled by hardware signals (such as SLP_Sx# or SUSPEND), the

CTLx combination changes when the host transitions from S0 to S3 and back. In this case,

the STCC5011/STCC5021 device can support remote wakeup of portable devices for the

following transitions (i.e. no VBUS discharge pulse and data switch ON):

•

SDP S0 (CTLx = 110) to and from SDP S3 (CTLx = 010) for all USB devices

•

SDP (CTLx = x10) and CDP S0 (CTLx = 111) to and from CDP S3 (CLx = 011) for low-

speed USB devices only.

If the host system is in S3 mode (CTLx = 011), the system automatically turns into DCP

auto-mode for already attached full-speed / high-speed USB devices or after any USB

device is detached. Thus, already attached full-speed / high-speed devices or newly

attached devices are charged without the need of CTLx transition.

If the S0 to S3 transition is managed by GPIO from the embedded controller, the easiest

solution is to keep the same levels on the CTLx pins (SDP or CDP modes). Therefore,

remote wakeup in S3 is supported for all USB devices but the system does not

automatically turn into DCP auto-mode.

5.3

VBUS discharge

The VBUS discharge pulse lasts for 350 ms typ. (tVBUS_REAPP) and is performed for any

transitions between the modes listed inTable 5, except the modes allowing remote wakeup

in S3 [transitions (x10) and (111) to/from (011)].

Permanent output discharge is provided in the following modes:

•

EN = 0, ATTACH_EN = 0, CTLx = xxx (ignored)

•

EN = 1, ATTACH_EN = 0, CTLx = 000.

STCC5021 Folha de dados(PDF) 14 Page - STMicroelectronics