INA211CIRSWT datasheet(21/44 Pages) TI1

21 / 44 page

OUT

IN+

IN-

REF

GND

V+

1 MW

2.7 V to 26 V

Reference

Voltage

Shunt

Load

Supply

Output

0.01 F

to 0.1 F

MMZ1608B601C

0.01 F

to 0.1 F

Device

INA210, INA211, INA212, INA213, INA214, INA215

www.ti.com

SBOS437J – MAY 2008 – REVISED FEBRUARY 2017

Product Folder Links: INA210 INA211 INA212 INA213 INA214 INA215

Submit Documentation Feedback

7.4.5 Improving Transient Robustness

Applications involving large input transients with excessive dV/dt above 2 kV per microsecond present at the

device input pins may cause damage to the internal ESD structures on version A devices. This potential damage

is a result of the internal latching of the ESD structure to ground when this transient occurs at the input. With

significant current available in most current-sensing applications, the large current flowing through the input

transient-triggered, ground-shorted ESD structure quickly results in damage to the silicon. External filtering can

be used to attenuate the transient signal prior to reaching the inputs to avoid the latching condition. Care must be

taken to ensure that external series input resistance does not significantly impact gain error accuracy. For

accuracy purposes, keep these resistances under 10 Ω if possible. Ferrite beads are recommended for this filter

because of their inherently low dc ohmic value. Ferrite beads with less than 10 Ω of resistance at dc and over

600 Ω of resistance at 100 MHz to 200 MHz are recommended. The recommended capacitor values for this filter

are between 0.01 µF and 0.1 µF to ensure adequate attenuation in the high-frequency region. This protection

scheme is shown in Figure 29.

Figure 29. Transient Protection

To minimize the cost of adding these external components to protect the device in applications where large

transient signals may be present, version B and C devices are now available with new ESD structures that are

not susceptible to this latching condition. Version B and C devices are incapable of sustaining these damage-

causing latched conditions so these devices do not have the same sensitivity to the transients that the version A

devices have, thus making the version B and C devices a better fit for these applications.

INA211CIRSWT Folha de dados(PDF) 21 Page - Texas Instruments

INA211CIRSWT Folha de dados(HTML) 21 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Folha de dados Download

Ligação URL