© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com

C1070_C0G_HV_FT-CAP • 1/23/2014

3

Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)

High Voltage with Flexible Termination System (HV FT-CAP), C0G Dielectric, 500VDC – 3000VDC (Commerical & Automotive Grade)

Qualification/Certification

Commercial Grade products are subject to internal qualification. Details regarding test methods and conditions are referenced in Table

4, Performance and Reliability.

Automotive Grade products meet or exceed the requirements outlined by the Automotive Electronics Council. Details regarding test

methods and conditions are referenced in document AEC–Q200, Stress Test Qualification for Passive Components. For additional

information regarding the Automotive Electronics Council and AEC–Q200, please visit their website at www.aecouncil.com.

Environmental Compliance

Lead (Pb)-Free, RoHS, and REACH compliant without exemptions (excluding SnPb termination finish option).

Electrical Parameters/Characteristics

Item

Parameters/Characteristics

Operating Temperature Range

-55°C to +125°C

Capacitance Change with Reference to +25°C and 0 VDC Applied (TCC)

±30 ppm/ºC

Aging Rate (Maximum % Capacitance Loss/Decade Hour)

0%

Dielectric Withstanding Voltage (DWV)

150% of rated voltage for voltage rating of < 1000 V

120% of rated voltage for voltage rating of ≥ 1000 V

(5 ±1 seconds and charge/discharge not exceeding 50 mA)

Dissipation Factor (DF) Maximum Limit @ 25ºC

0.1%

Insulation Resistance (IR) Limit @ 25°C

1000 megohm microfarads or 100 GΩ

(500 VDC applied for 120 ±5 secs @ 25°C)

To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.

Capacitance and Dissipation Factor (DF) measured under the following conditions:

1 MHz ±100 kHz and 1.0 Vrms ±0.2 V if capacitance ≤ 1,000 pF

1 kHz ± 50 Hz and 1.0 Vrms ±0.2 V if capacitance > 1,000 pF

Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known as

Automatic Level Control (ALC). The ALC feature should be switched to "ON."

Post Environmental Limits

High Temperature Life, Biased Humidity, Moisture Resistance

Dielectric

Rated DC

Voltage

Capacitance

Value

Dissipation Factor

(Maximum %)

Capacitance

Shift

Insulation

Resistance

C0G

All

All

0.5

0.3% or ±0.25 pF 10% of Initial Limit