UG-739

ADA4571R-EBZ User Guide

OVERVIEW OF THE MAIN GUI WINDOW

Figure 6 shows the main GUI window, as it appears, after

launching the GUI.

When the program is first launched the SDP controller board

must be recognized by the GUI before proceeding. Pressing

Connect SDP reads the EEPROM ID of the motherboard to

ensure the correct program is being used. If the SDP controller

board is not connected or if the drivers are not installed

correctly an error message will be shown. Ensure that the

drivers are installed correctly if this occurs.

After the SDP control board is properly connected and the

program recognizes the motherboard, the Instructions tab

appears. Click the Read tab to begin.

Initially all of the figures will be blank. To begin press Run (see

Figure 6). The various output graphs are explained in detail in

the following sections.

There are two different categories of output waveforms as

indicated by the GUI. The waveforms on the top of each tab,

indicated as Uncorrected Plots, are without any post processing

to correct for output offset before calculations are done on the

raw data. In the case of the bottom waveforms, indicated as

Offset Corrected Plots, the offset of each channel is subtracted

from the raw data before completing any further calculations.

These differences are discussed in further detail for each

waveform in the Raw Waveforms section.

Figure 6. ADA4571 Main Window

Rev. 0 | Page 6 of 13