DP7221 datasheet(8/16 Pages) COPAL

8 / 16 page

DP7221

Doc. No. MD-2113 Rev. K

Characteristics subject to change without notice

INSTRUCTIONS AND REGISTER

DESCRIPTION

Instructions

SLAVE ADDRESS BYTE

The first byte sent to the DP7221 from the master/

processor is called the Slave/DP Address Byte. The

most significant four bits of the slave address are a

device type identifier. These bits for the DP7221 are

fixed at 0101[B] (refer to Table 1).

The next four bits, A3 - A0, are the internal slave

address and must match the physical device address

which is defined by the state of the A3 - A0 input pins

for the DP7221 to successfully continue the com–

mand sequence. Only the device which slave address

matches the incoming device address sent by the

master executes the instruction. The A3 - A0 inputs

can be actively driven by CMOS input signals or tied

to VCC or VSS.

INSTRUCTION BYTE

The next byte sent to the DP7221 contains the

instruction and register pointer information. The four

most significant bits used provide the instruction

opcode I [3:0]. The P0 bit points to one of the Wiper

Control Registers. The least two significant bits, R1

and R0, point to one of the four data registers of each

associated potentiometer. The format is shown in

Table 2.

Data Register Selection

Data Register Selected

DR0

DR1

DR2

DR3

Table 1. Identification Byte Format

Table 2. Instruction Byte Format

ID3

ID2

ID1

ID0

010

(MSB)

(LSB)

Device Type

Identifier

Slave Address

0P0

(MSB)

(LSB)

Instruction

Data Register

WCR/Pot Selection

DP7221 Folha de dados(PDF) 8 Page - Copal Electronics

DP7221 Folha de dados(HTML) 8 Page - Copal Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Folha de dados Download

Ligação URL